This topic has 1 reply, 2 voices, and was last updated 9 years, 6 months ago by 
.
- Posts
Hi,
As part of my Mechanical Engineering project i decided to integrate your LT2 Multi-Axis arm in my design.I need additional information regarding to the arm specs, The Arm Power consumption (Watts) and general electric information (Voltage and current).
Hi. The design details of the design are proprietary. It requires 24VDC and you should have capacity up to 25 or 30Amps (that would be extreme – fully loaded). When the arm is just sitting there, only the control board will pull power (couple hundred miliAmps). Each joint is only a couple amps without a load. All you need to do is supply the power, the arm comes completely wired and configured. A serial signal (we provide the protocol) is used to control the arm. If you would rather we can make it RC signal (in which case you would have a RC signal for each axis).
You must be logged in to reply to this topic.