@danfromnj
Dan replied to the topic Quadrature Buffer Encoder Data in the forum Electrical & Controls 8 years, 10 months ago
Thank you for your help. I have the Arduino mega reading the SPI signal from the encoder buffers. For some reason, I was having a problem with my USB host shield that was breaking the SPI signal. When I switched the USB host shield to a different one, I started getting a valid connection.
I am having a different problem now. One of the…[Read more]
-
Dan replied to the topic Quadrature Buffer Encoder Data in the forum Electrical & Controls 8 years, 10 months ago
Do the jumper need to be bridged even when using the encoder pull up board? This would put 2k of resistance between the a & b sensors and the encoder buffer chip.
-
Dan replied to the topic Quadrature Buffer Encoder Data in the forum Electrical & Controls 8 years, 10 months ago
I am using the board how it came from superdroidrobots. I tested with a multimeter and thought that the solder jumpers came pre-soldered. Is this correct? Also, I have the motor encoders hooked up with the following pull up board.
I do not…[Read more]
-
Dan replied to the topic Quadrature Buffer Encoder Data in the forum Electrical & Controls 8 years, 10 months ago
I am using the board how it came from superdroidrobots. I tested with a multimeter and thought that the solder jumpers came pre-soldered. Is this correct? Also, I have the motor encoders hooked up with the following pull up board.
Thanks
Dan -
Dan started the topic Quadrature Buffer Encoder Data in the forum Electrical & Controls 8 years, 10 months ago
Hello-
I recently purchased a few quadrature encoder buffers from your website. I am connecting them to the ig52 motors that I also got from you guys. I believe that I have it hooked up correctly, but the data I getting from the encoder doesn’t make sense.
I am using an arduino mega for my mcu. My setup is as follows.
Front Right (FR) motor…[Read more]
-
Dan started the topic Quadrature Buffer Encoder Data in the forum Electrical & Controls 8 years, 10 months ago
Hello-
I recently purchased a few quadrature encoder buffers from your website. I am connecting them to the ig52 motors that I also got from you guys. I believe that I have it hooked up correctly, but the data I getting from the encoder doesn’t make sense.
I am using an arduino mega for my mcu. My setup is as follows.
Front Right (FR) motor…[Read more]
-
Dan became a registered member 8 years, 10 months ago
