@johnga
JohnGa replied to the topic Need switch to control power and load circuits in robot in the forum Electrical & Controls 4 years, 8 months ago
Thank you so much for the clear wiring diagram. This gives me a lot of confidence to proceed. One more question: What power ratings should the switch in the load circuit have?
-
JohnGa replied to the topic Need switch to control power and load circuits in robot in the forum Electrical & Controls 4 years, 8 months ago
Hello,
I want to use an XLR charging port. This is my first project involving power, and don’t want to fry expensive electronics/batteries. Can you please give me a quick and dirty schematic for what you recommended? If I were to go that route, what kind of a switch do I need? Where should the fuses go?Thanks.
-
JohnGa started the topic Need switch to control power and load circuits in robot in the forum Electrical & Controls 4 years, 8 months ago
Hello,
In my RC Lawn mower project, I am using a Sabertooth 2×32 controller. The power is coming from 2 12V SLA batteries wired in series. I want to use a DPDT, ON-(OFF)-ON switch. The switch will allow me to turn OFF both load and power circuits. In one ON position, it will allow me to use the charging port. In another ON position, the load…[Read more] -
JohnGa became a registered member 4 years, 8 months ago
