@nickfragale
Nick Fragale replied to the topic Motor Wiring in the forum Electrical & Controls 7 years, 12 months ago
Great, thank you. But those are the wire-board connectors.
Do you also have the wire-wire connector digikey numbers?
-
Nick Fragale replied to the topic Motor Wiring in the forum Electrical & Controls 8 years ago
Hi,
If you buy motors with encoders they come with connectors (I have the IG42 122RPM)
Where can I find the mating connectors? If you could provide a digikey part number that would be wonderful.
-
Nick Fragale replied to the topic Kangaroo Auto tune in the forum Electrical & Controls 8 years, 1 month ago
Hi,
Thanks for the quick reply. How do you do manual tune a kangaroo? Do you just use the DEscribe software to edit the tuning parameters?
-
Nick Fragale started the topic Kangaroo Auto tune in the forum Electrical & Controls 8 years, 1 month ago
Hi,
I’m using one of the 4-wheel skid steer robotics kits. I added a kangaroo so that I can get encoder feedback. The robots about 60lbs right now. When I set the robot on the ground and run the autotune sequence it works fine until the turning part, and then it always fails with Error 3 “Control Error. The system either lost control, failed to…[Read more]
-
Nick Fragale became a registered member 8 years, 1 month ago
