@serg
Serg replied to the topic chassis for a pixhawk autopilot in the forum General Robot Discussion Topics 9 years, 2 months ago
thanks!
the TP-132-032 with 265 RPM motors would drive up to 7.6km/h which should be sufficient for my needs. (should have said 5-7 kilometers per hour, not mile per hour)
the scenario I have in mind is very close to the lawn mower, and it doesn’t have to turn 180 degrees when moving to the next lane – just do an s-curve maneuver to shift ~1.5…[Read more]-
Serg started the topic chassis for a pixhawk autopilot in the forum General Robot Discussion Topics 9 years, 2 months ago
I am looking into building a rover (http://rover.ardupilot.com/) with a pixhawk autopilot (https://store.3dr.com/products/3dr-pixhawk) but the chassis they usually employ are a bit too weak, and so I am considering your 4WD All Terrain Robot Platform – IG32 SB (TP-132-032)
as a sturdier and more load bearing base. It will need to carry ~5-6lb of…[Read more] -
Serg started the topic chassis for a pixhawk autopilot in the forum General Robot Discussion Topics 9 years, 2 months ago
I am looking into building a rover (http://rover.ardupilot.com/) with a pixhawk autopilot (https://store.3dr.com/products/3dr-pixhawk) but the chassis they usually employ are a bit too weak, and so I am considering your 4WD All Terrain Robot Platform – IG32 SB (TP-132-032)
as a sturdier and more load bearing base. It will need to carry ~5-6lb of…[Read more] -
Serg became a registered member 9 years, 2 months ago
