This topic has 5 replies, 2 voices, and was last updated 5 years ago by 
.
- Posts
My 4wd electric wheelchair motor drives good for about 30 seconds and then takes off like a bat out of hell, spinning or full throttle in one direction? The wheel chair motors on each side are mounted to a piece of steel bolted to the frame. Not sure if a current is reaching both motors since they’re mounted on same surface? First time building here need some help please.
Hi Kurt,
just a few questions.
What are you using for a motor controller?
Are the brakes disengaged?
are you using encoders?The brakes were removed so the little pin from the brake is exposed but no wiring is going to it. I drilled holes in the plywood so yhe tmotors could mount flush to the underside of the bot.
You must be logged in to reply to this topic.