mahadh92

thank u so much

and if i have 4 motors but i can only control them by pairs.. i only have two channels and control each two motors as one.. u have any suggestions?

i found the solution of the problem.
the problem is that the datasheet shows the purple should go with channel B and blue with A.
but the motors that we received provide an opposite connection such as the one shows on this picture:
http://www.superdroidrobots.com/images/TE-179-000-C.jpg

i changed the channels wires and things are working great…[Read more]

thank u so much.. yes i only have the wires stabbed into DB15.
thank u so much for the help.
i will check them.

yes thank u i already did all of that.. the problem is that i get some values only when i move the pullup board with my hand… that’s why i’m asking where should i install it in order to feel the rotations of the motor?

is there any video showing where to install the board ? i think it has a photo transistor or so

ok when i move the motors using the sliders.. nothing happens.
when i move the pullup board .. i get some values.
should i install the board in a specific way? where? there’s no much documentation about this stuff

Thank you so much.
the second question i’m still confused about it though.

if i chose to order this motor controller:
RoboteQ SDC2150 – 2x20A 50V Motor Controller with Encoder Input (Add $225.00)

how many motor controller will i get? and how will it control the 4 mototrs?

Thanks a lot

THANK YOU SO MUCH EVERYONE