Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 19, 2020 at 9:33 am #8103
     nathmaheshmp
    Participant

    I can clear the encoder readings fine from the counts that the arduino is reading? If that is the case, you can use the command “Encoder1.clearEncoderCount()” example Arduino code, but I need to know when that index pulse comes through so that I can execute it accordingly.

    October 12, 2020 at 5:05 am #8102
     nathmaheshmp
    Participant

    Are you trying to reset the number of counts that the arduino is reading? If that is the case, you can use the command “Encoder1.clearEncoderCount()”

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)