Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 2, 2015 at 1:01 pm #2093
     steve
    Participant

    Great, thank you. On the back of my IG42 motor, there are 4 small holes that look to be arranged around the shaft in a square of about 0.7 inches. These holes appear to be tapped but I cannot tell for sure because they are underneath the encoder, but they are not in the part drawings either. I am hoping to use them for mounting the base of a US Digital encoder… Do you have more information about these holes? Thank you!

    February 27, 2015 at 6:51 pm #2088
     steve
    Participant

    Hello,

    I am interested in the encoder on the IG42 motor. I have one IG42 w/encoder already that does 10 PPR. However, I see in the spec sheet that the precision can go up to 38 PPR. How can I do this? Is this hardware that needs to be purchased with the motor and assembled by SuperDroid? Thank you!

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)